Its been a long time!
So the question is what have I been doing the last year, well I have been building 3D Printers and started a small print shop. In the next few days I will be posting the BOM for the printers
So the question is what have I been doing the last year, well I have been building 3D Printers and started a small print shop. In the next few days I will be posting the BOM for the printers
I found myself in a situation where I needed to be able to ping a computer and based on the response power cycle the machine. The Arduino pings the target system and determines if the machine is responsive.
Virtual currency is term that just screams fake right? Have you heard of Bitcoin, Litecoin or Dogecoin? There is countless other forms of virtual currency out there right now as well. Virtual currency has exploded over the last 3 months.
Well I have been out of the loop for a while but this week I will going over some projects that kids can do!
Building a 3D printer is certainly a test of patience and will. When building a non-standard 3D printer it becomes easily apparent what kind of undertaking it may become. [singlepic id=154 w=320 h=240 mode=watermark float=center] The gantry that
I won’t go through the instructions on how to build a 3D printer. They can be found pretty much everywhere online. What I will do is show the progress that has been made so far with my garage printer.
Coming up this summer I will be building a 3D printer. Did you know that they draw a little bit of juice? Well just so happens that I had a Dell Power Edge 2650 laying in the basement of my house.
Had the privilege today of acquiring a new used tool. I was able to pick up a EMCO Compact 5 Mini-Lathe and Mill. Here is what I got off of Craigslist today for $140. [singlepic id=134 w=320 h=240 mode=watermark
Here is a short video of a Cross Slide Repair. http://www.youtube.com/watch?v=LRN01uw8J0I Fecke – KJ4ZRZ
Here is short video of what to check on a lathe cross slide and way. http://www.youtube.com/watch?v=isPEj01AlDE Fecke – KJ4ZRZ
So its the first night of the build. I will be doing all the fabrication tonight. I have made every attempt to only use a drill, hacksaw and clamp to produce the parts for this car. So lets start at the
[singlepic id=108 w=320 h=240 mode=watermark float=center] Well as it turns out I think this should be self-guided week! So here is what is on my desk right now. Remember those New Bright cars? Lets skip the duct-tape this